Atlantis Solar SK Series Guia de Instalação Página 26

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 51
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 25
26
Common Failures Diagnosis and Elimination
Non-failure Phenomena
1. When you start up or shut down the Atlantis Solar Air conditioner, sometimes you will
hear sizzle sound, which is the flowing sound of the cooling agent, and is not a
malfunction.
2. The Atlantis Solar Air conditioner cannot restart at once after stops, though it is
switched on. Within 3 minutes, the compressor will not run for the cooling, dehumidifying
and heating.
3. Sometimes, the Atlantis Solar Air conditioner inbreathes the bad smell so as to blow out
the mawkish air. Under such condition, no failure is with the Atlantis Solar Air conditioner.
The filter screen is to be rinsed.
4. When heating, the indoor machine and the outdoor machine may stop simultaneity, but
the compressor still runs. This is to defrost. The heating performance will continue after
defrosting finished.
5. When heating, the outdoor machine may generate water flow or hydrosphere. This is a
result of defrosting and thawing, and is not a malfunction.
6. After the heat pump Atlantis Solar Air conditioner, which is applied in the Inner Mongolia,
starts or stops, the air conditioner may beep. This is a result of self balanced pressure,
and is not a malfunction.
Clew of Saving Energy:
Never jam the air inlet and the air outlet of the Atlantis Solar Air conditioner. The air
conditioner will not run normally and may be damaged if the outlets are obstructed. When
cooling, please avoid direct sun radiation into the room of the Atlantis Solar Air conditioner.
Please adopt the sun shield or curtains. If the wall and ceiling of the room is heated by
sunshine, the period of cooling will be long.
Please always keep the air filter screen clean. Filter screen jamming will greatly reduce
the efficiency of the air conditioner. Keep the window, door and any openings closed, so
as to avoid cooling air escaping.
Failure Display Status List
Failure Type Display Status
Indoor Temperature Sensor Failure E1
Indoor Coiler Transmitter Failure E2
System Failure E3
Indoor Blower Failure E4
If any of the above-mentioned failures happen, please contact the distributor or the after
service center.
Vista de página 25
1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 50 51

Comentários a estes Manuais

Sem comentários